No Results Found
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.
International Rectifier IR35221MTRPBF QFN(40) Device
Contact Inside Sales
IMPORTANT:
| Device Type: | Infineon Flexible Power Management Unit |
| Device Memory Type: | Configuration Registers |
| Algorithm Programming Method: | PMBus |
| Supported Data File Format: | Single image three column configuration file(.txt) |
| Serialization Supported: | No |
Memory Organization:
| Memory Type |
Attributes(*) |
Included in Default Range (Y/N) | DUT PhysicalByte Address (hex) | BPWin BufferByte Address (hex) |
| Configuration Registers | R/W/E | Yes | 0000 – 0BFF | Determined by data file |
| Default Algorithm Range | — | — | 0000 – 0BFF | Determined by data file |
* R/W/E: readable and rewritable if not locked. Special Device Considerations:
| 1. | Blank Check will check if any CNFG or User section writes have been performed. It is strongly recommended to leave Blank Check enabled. The first CNFG image may be programmed from the semihouse. Blank Check will pass if only one CNFG image is written. |
| 2. | The CNFG section is limited to five image writes. If Blank Check is disabled and there are no more write attempts the CNFG section will not re-program correctly. |
| 3. | The User section is limited to 29 image writes. This algorithm will program the User image number as specified in the data file. If Blank Check is disabled and a particular image has already been written the image will not re-program correctly. |
| 4. | This algorithm will only attempt to verify the last User image in the data file by image number. |
| 5. | The CNFG section should be programmed at least once. Otherwise the User section may not verify correctly. |
| 6. | This algorithm will only program and verify the register ranges listed in the Configuration Register Mapping table above. The masks in the data file will determine which bits to verify. |
| 7. | Operations on the TRIM section are not supported. |
| 8. | Config options can be used to disable CNFG or User section while programming. |
| 9. | Operations on the TRIM section are not supported. |
‘
Note: Lead Time is working days (5 days per week)
Adapters for Automated Programmers
| 9th Gen |
| FVE4ASMR40QNY |
Adapters for Manual Programmers
| 9th Gen |
| FVE4ASMR40QNY |
Adapters for Engineering Programmers
Last Updated: 05/18/2023
Additional information
| 8-bit Bytes | 1048576 |
|---|---|
| Manufacturer | International Rectifier |
| Packages | QFN(40) |
| Part Number | IR35221MTRPBF |
| Vcc(program) | 3.3 |
Reviews
There are no reviews yet.