Freescale Semiconductor MC9S08GT16AVFDE(Osc Trim) QFN(48) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: The following describes the Data Pattern setup: Addresses $C000-$FFFF are FLASH. Erase command will erase entire FLASH memory map including factory trim at address $FFBE(NVICGTRM). There are some locations reserved in the FLASH memory map. The following are reserved addresses: $FFB8-$FFBC. These locations will be ignored during Program Read and Verify. Erase command will erase entire FLASH memory map included reserved memory. The lower two bits (Bit1 and Bit0) at address $FFBF are security bits (SEC01:SEC00). They are ignored during Program and Verify and read 1:0 if unsecured during Read and Compare. Program command will re-trim internal Oscillator (FLL internal reference clock ) and program to $FFBE(NVICGTRM). The device is trimmed based on the following conditions: – 4.443Mhz bus rate – 3V power supply – 2% accuracy – Trim is valid to the circuitry on the Socket Module on which it is performed.