Atmel ATMEGA128-16MN LAP(64) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: Buffer address range 0-1FFFFh is for FLASH Memory and 20000h-20FFFh isfor EEPROM Data Memory. Erase will clear the Configuration Bits.Due to parallel programming mode specifications device will only beverified from 4.5V to 5.5V.You may program the Calibration informationto any location in the device through the Device Configure menu.New devices may automatically calibrate the RC Oscillator.Please set the CALIBRATION option to DISABLE(default) to use automatic calibration.You also can set the fuse from Fuse Low Byte Fuse High Byte and Extended Fuse Byteunder Device Configure menu. The fuses are mapped into the fuse bytes in the followingway. Fuse Low Byte: [Bit0:CKSEL0 Bit1:CKSEL1 Bit2:CKSEL2 Bit3:CKSEL3 Bit4:SUT0 Bit5:SUT1Bit6:BODEN Bit7:BODLEVEL]; Fuse High Byte: [Bit0:BOOTRST Bit1:BOOTSZ0 Bit2:BOOTSZ1Bit3: EESAVE Bit4:CKOPT Bit5:SPIEN Bit6:JTAGEN Bit7:OCDEN];Extended Fuse Byte: [Bit0:WDTON Bit1:M103C].Please refer to the device specifications for detailed information.CAL BYTE ADDRESS menu has been added in Device Configure menu to select one of theaddresses (0h-3h) in the signature row high byte for 1 2 4 or 8 MHz internal RC Oscillator Calibration.COMPARE operation will only verify data read from the device against data in the buffer.