Atmel ATmega168A-AU(Calibration) QFP(32) Device
Adapters for Automated Programmers
| 8th Gen | 9th Gen |
| FVE4ASMR32TQFG, FVE4ASMR32TQFG | FVE4ASMR32TQFG |
Adapters for Manual Programmers
| 8th Gen | 9th Gen |
| FVE4ASMR32TQFG, FVE4ASMR32TQFG | FVE4ASMR32TQFG |
Adapters for Engineering Programmers
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: In the Buffer address [0000h-3FFFh] is for FLASH Program Memory and address [4000h-41FFh]is for EEPROM Data Memory. There are 2 Calibration Byte residing in the signature rowLow byte of address 0h and high byte of address 1h for 8.0MHz internal RC Oscillator calibration.To program this calibration byte into the memory in Device > Configure1)Set CALIBRATION to ENABLE2)Set CALIBRATION ADDRESS to the memory address [0000h-41FFh] you want to program the Calibration Byte.Default CALIBRATION ADDRESS at Data Pattern 4000h(EEPROM address 0 and 4001h(EEPROM address 1).
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Atmel |
|---|---|
| Vcc(program) | 5 |
| Packages | QFP(32) |
| Part Number | ATmega168A-AU |
| 8-bit Bytes | |
| Package | |
| Bytes | 0h-3FFFh; 4000h-41FFh |
| ByteWidth | ATmega168A-AU(Calibration) (ID=9406h) |
| VppProgram | 16896 |
| ElectricalErase | 5 |