Atmel ATtiny28L-4AC QFP(32) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASM32TQA, FASM32TQC, FASM32TQ | FASM32TQA, FASM32TQC, FASM32TQ |
Adapters for Manual Programmers
| 6th Gen | 7th Gen |
| FSM32TQA, FSM32TQC, FSM32TQ, FASM32TQA, FASM32TQC, FASM32TQ | FSM32TQA, FSM32TQC, FSM32TQ, FASM32TQA, FASM32TQC, FASM32TQ |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSM32TQA, FSM32TQC, FSM32TQ, FASM32TQA, FASM32TQC, FASM32TQ | FSM32TQA, FSM32TQC, FSM32TQ, FASM32TQA, FASM32TQC, FASM32TQ |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: This device has a Fuse Low Byte that can be set under Device Configure menu.Bit7..5 of the Fuse Low Byte are RESERVED and must be set to 1′.If CALIBRATION is set ENABLE the Calibration Byte can be programmed into any address[000h-7FFh] in the flash memory. The address is set in CALIBRATION ADDRESS option.CAL BYTE ADDRESS option is to set address 0h in the signature row high bytefor 1.2MHz internal RC Oscillator Calibration.COMPARE operation will only verify data read from the device against data in the buffer.New devices may automatically calibrate the RC Oscillator.Please set the CALIBRATION option to DISABLE(default) to use automatic calibration.Calibration byte will be ignored during compare regardless of the Calibration settings in Device Configure menu.Due to parallel programming mode device can only be verified at 4.5V and 5.5V. ‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Atmel |
|---|---|
| Packages | DIP(28) QFP(32) |
| Part Number | ATtiny28L-4AC |
| Set programming | Yes |
| Vcc(program) | 5 |
| 8-bit Bytes | |
| Package |