Cypress S25FL512SAGBHID11 BGA(24) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: 512M-bit Serial Flash. This algorithm uses Standard SPI mode to Program and Verify/Read the device. The status register bits can be set under Device Config > Configure . Erase must be selected if device to be programmed already has QE bit enabled. The default Device Range is set to [0000000h-3FFFFFFh]. Please modify the range under Device Config > Range if any of the Security Registers need to be included. The correct password value located in the range [4000400h-4000407h] may be read only after it is programmed and before the Password Mode has been selected by programming the Password Protection Mode bit to 0 in the ASP Register (ASP[2]). The OTP region is located in the range [4000000h-40003FFh]. The Factory Programmed 128-bit random number located at the beginning of the OTP region cannot be programmed and data in this region will not be shown in the Buffer Editor. OTP Lock bits are located in the Buffer location [4000010h-4000013h] and Reserved bits are located at [4000014h-400001Fh]. The device lock bits may be programmed under Device Congig > Configure. Each Group is devided into 256K Bytes of data