Freescale Semiconductor MC68HC908QY4CDWE(Factory Trim) SOIC(16) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen | 9th Gen |
| FASM16SC, FASM28SH, WASM16SC (repl.) | FASM16SC, FASM28SH, WASM16SC (repl.) | WASM16SC |
Adapters for Manual Programmers
| 6th Gen | 7th Gen | 9th Gen |
| FSM16SC, FSM28SH, FASM16SC, FASM28SH, WASM16SC (repl.) | FSM16SC, FSM28SH, FASM16SC, FASM28SH, WASM16SC (repl.) | WASM16SC |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSM16SC, FSM28SH, FASM16SC, FASM28SH, WASM16SC (repl.) | FSM16SC, FSM28SH, FASM16SC, FASM28SH, WASM16SC (repl.) |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT:
| Device Type: | M68HC08 Family of 8-bit microcontrollers |
| Device Size: | 4096 bytes of user Flash. |
| Algorithm Programming Method: | Monitor Mode serial protocol + Custom bootloader |
Memory Organization:
| Memory Type |
Attributes(*)
|
Included in default Range (Y/N) | DUT Physical Byte Address(hex)(if this area is selected/Activated) | BPWin Buffer Byte Address(hex) | FLASH | R/W/E | Yes | 0000 EE00 – 0000 FFFF | 0000 EE00 – 0000 FFFF |
* R:Read only W: One time programmable (OTP) R/W: readable and one time programmable (OTP) R/W/E: readable and rewritable if not locked. Any configurations listed under Device-Specific’ in the menu item Device-> Settings will be written to the DUT during ‘Program’ operation. Special Device Considerations: Microcontroller with FLASH. The following describes the buffer setup: The addresses $EE00 to $FDFF are Flash. The addresses $FFB0 to $FFBD are Flash. The addresses $FFC2 to $FFCF are Flash. The addresses $FFD0 to $FFFF are Flash User Vectors. The address $FFBE is FLASH Block Protection Register(FLBPR). This device has an eight bytes security feature from $FFF6 to $FFFD. To read a programmed device with the security feature the buffer or Device/Configure must be filled with correct data from address $FFF6 to $FFFD. Incorrect data at these locations will prevent access to the device. Erasing the device will erase the clock trim values stored at locations $FFC0 and $FFC1. If these values need to be saved on blank devices from the Factory disable erase before program. ‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Freescale Semiconductor |
|---|---|
| Packages | SOIC(16) |
| Part Number | MC68HC908QY4CDWE |
| Vcc(program) | 5 |
| Package | |
| 8-bit Bytes |