Freescale Semiconductor MC908AZ32ACFUE QFP(64) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: Microcontroller with FLASH and EEPROM.The following describes the buffer setup:EEPROM at locations [$0800-$09FF] ($FF when blank).FLASH at locations [$8000-$FDFF] ($FF when blank).Registers EEDIVHNVR at $FE10 EEDIVLNVR at $FE11 ($FF when blank);EENVR at $FE1C (factory programmed $F0);FLBPR at $FF80 ($FF when blank).Vectors at locations [$FFCC-$FFFF] ($FF when blank).Security bytes at [$FFF6-$FFFD].Other address locations are ignored.To read a programmed device the buffer must be filled with correct data at addresses [$FFF6-$FFFD].Make sure to fill buffer with right data for the EEDIVHNVR and the EENVR registers.These registers have one time programmable bits that protect portions of EEPROM permanently.The Erase command erases the FLASH only.