Freescale Semiconductor MC9S08GT16-B DIP(42) Device
Adapters for Manual Programmers
| 6th Gen | 7th Gen |
| FSM56SDB | FSM56SDB |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSM56SDB | FSM56SDB |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: The following describes the buffer setup:Addresses $C000-$FFFF are FLASH.There are some location reserved in the FLASH memory map.The following are reserved addresses: $FFB8-$FFBC and $FFBE.These locations will be ignored during Program Read and Verify.Erase command will be erase entire FLASH memory map included reserved memory.To secure the device use SECURE command.Erasing the device will erase the clock trim values stored at location $FFBE.If these values need to be saved on blank devices from the Factorydisable Erase before Program.This algorithm does not program the ICG trim at address $FFBE.
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Freescale Semiconductor |
|---|---|
| Packages | DIP(42) |
| Part Number | MC9S08GT16-B |
| Vcc(program) | 3 |
| 8-bit Bytes | |
| Package |