Freescale Semiconductor MC9S08QG4MFK(Osc Trim) QFN(24) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen | 9th Gen |
| FASM24QFNH, LASM24QFNH (repl.) | FASM24QFNH, LASM24QFNH (repl.) | LASM24QFNH |
Adapters for Manual Programmers
| 6th Gen | 7th Gen | 9th Gen |
| FSM24QFNH, FASM24QFNH, LASM24QFNH (repl.) | FSM24QFNH, FASM24QFNH, LASM24QFNH (repl.) | LASM24QFNH |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSM24QFNH, FASM24QFNH, LASM24QFNH (repl.) | FSM24QFNH, FASM24QFNH, LASM24QFNH (repl.) |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: The following describes the buffer setup: Addresses $F000-$FFFF are FLASH. Erase command will erase entire FLASH memory map including factory trim at address $FFAE(FTRIM) and $FFAF(ICSTRIM). Program command will re-trim internal Oscillator (FEI mode) on 8Mhz bus rate and program to $FFAE(FTRIM)and $FFAF(ICSTRIM). Trimmed value can be viewed in Data Pattern at these addresses with the Read command. To secure the device use Secure command.
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Freescale Semiconductor |
|---|---|
| Packages | QFN(24) |
| Part Number | MC9S08QG4MFK |
| Vcc(program) | 2.6 |
| Package | |
| 8-bit Bytes |