Freescale Semiconductor MC9S12A128BMFU QFP(80) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASMR80QCA, FASM80QCA | FASMR80QCA, FASM80QCA |
Adapters for Manual Programmers
| 6th Gen | 7th Gen |
| FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA | FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA | FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: The following describes the Buffer setup:Start address of EEPROM can be set under Device Configure.The EEPROM memory can be mapped to any 2Kbyte boundary in the MCU address ranges [$0-$FFFF].Please check data file. The start address of EEPROM must match the data file (Buffer).Addresses $E0000-$E3FFF are FLASH PAGE $38.Addresses $E4000-$E7FFF are FLASH PAGE $39.Addresses $E8000-$EBFFF are FLASH PAGE $3A.Addresses $EC000-$EFFFF are FLASH PAGE $3B.Addresses $F0000-$F3FFF are FLASH PAGE $3C.Addresses $F4000-$F7FFF are FLASH PAGE $3D.Addresses $F8000-$FBFFF are FLASH PAGE $3E.Addresses $FC000-$FFFFF are FLASH PAGE $3F.There are two security bits in the FLASH PAGE $3F.These bits (SEC01 SEC00) are Bit1 and Bit0 of address $FFF0F in the buffer.These locations will be masked out during programming and these bitswill be programmed to 0′ when the device is secured. To secure the deviceplease use the Device Secure command.Please set Device Options ‘Byte order’ to: ‘MSB=0LSB=1′(Big-Endian).This algorithm supports margin verification. ‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Freescale Semiconductor |
|---|---|
| Packages | QFP(80) |
| Part Number | MC9S12A128BMFU |
| Vcc(program) | 5 |
| Package |