Freescale Semiconductor MC9S12KG256CPV(Banked S-Record) QFP(112) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: The following describes the Buffer setup:Start address of EEPROM can be set under Device Configure.The EEPROM memory can be mapped to any 4Kbyte boundary in the MCU address ranges [$0-$BFFF].Please check data file. The start address of EEPROM must match the data file (Buffer).Addresses $308000-$30BFFF are FLASH PAGE $30.Addresses $318000-$31BFFF are FLASH PAGE $31.Addresses $328000-$32BFFF are FLASH PAGE $32.Addresses $338000-$33BFFF are FLASH PAGE $33.Addresses $348000-$34BFFF are FLASH PAGE $34.Addresses $358000-$35BFFF are FLASH PAGE $35.Addresses $368000-$36BFFF are FLASH PAGE $36.Addresses $378000-$37BFFF are FLASH PAGE $37.Addresses $388000-$38BFFF are FLASH PAGE $38.Addresses $398000-$39BFFF are FLASH PAGE $39.Addresses $3A8000-$3ABFFF are FLASH PAGE $3A.Addresses $3B8000-$3BBFFF are FLASH PAGE $3B.Addresses $3C8000-$3CBFFF are FLASH PAGE $3C.Addresses $3D8000-$3DBFFF are FLASH PAGE $3D.Addresses $00C000-$00FFFF are FLASH PAGE $3F.FLASH PAGE $3E can be set as Paged or Unpaged under Device configure.There are two security bits in the FLASH PAGE $3F.These bits (SEC01 SEC00) are Bit1 and Bit0 of address $FF0F in the buffer.These locations will be masked out during programming and these bitswill be programmed to 0′ when the device is secured. To secure the deviceplease use the Device Secure command.Please set Device Options ‘Byte order’ to: ‘MSB=0LSB=1′(Big-Endian). ‘