NEC uPD76F0193 BGA(305) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: 3-Wire Serial I/O Mode. Code Flash is mapped to address space 0000000h-01FFFFFh. Data Flash is mapped to address space 2000000h-2007FFFh (2000000h-200FFFFFh in the Data Pattern with ID Tag). Data Pattern containing Data Flash must include valid ID Tags. Erase function for a Blank secured device is not supported. The Option Byte 0 can be set under Device->Configure and programmed with Secure command. Security for this device cannot be verified. The Security Byte can be set under Device->Configure and programmed with Secure command. In order to program this Byte please enable Secure. Set Bit 1 to 0 will disable Boot cluster rewrite. Set Bit 2 to 0 will disable Block Erase. Set Bit 3 to 0 will disable Chip Erase. Set Bit 4 to 0 will disable Porgram. Set Bit 5 to 0 will disable Read. Bits 0 6 and 7 are reserved and should be set to 1s. Bit 4 and 5 can be erased through Chip Erase but once bit 3 is programmed to 0 the whole chip is secured and no further operations can be performed. Once Bit 1 is programmed to 0 the boot block clusters specified are secured and no further operations can be performed. This algorithm supports silicon version ES2.0 and ES3.1. Mixing samples is not recommended. Correct Silicon Version can be selected under Device > Config.