NXP Semiconductors LPC1115JBD48/303 QFP(48) Device
Adapters for Automated Programmers
| 8th Gen | 9th Gen |
| FVE4ASMR48LQFPC, FVE4ASMR48LQFPC | FVE4ASMR48LQFPC |
Adapters for Manual Programmers
| 8th Gen | 9th Gen |
| FVE4ASMR48LQFPC, FVE4ASMR48LQFPC | FVE4ASMR48LQFPC |
Adapters for Engineering Programmers
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: Microcontroller with Flash Memory. Flash memory is located at address range 0000h-FFFFh. Code read protection (CRP) is enabled by programming the Flash address location 2FCh (User flash sector 0). CRP works in conjunction with the following values (Little Endian Byte format): CRP1 is enabled if value 12345678h(305419896 Decimal) is programmed. Access to chip via the SWD pins is disabled. CRP2 is enabled if value 87654321h(2271560481 Decimal) is programmed. Access to chip via the SWD pins is disabled. The following ISP commands are also disabled: Read Memory Write to RAM Go Copy RAM to flash and Compare. ISP erase command only allows erasure of all user sectors. CRP3 is enabled if value 43218765h(1126270821 Decimal) is programmed. Access to chip via the SWD pins is disabled. ISP entry by pulling P2.10 LOW is disabled if a valid user code is present in flash sector 0. When this mode is invoked no future factory testing can be performed on the device.
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| 8-bit Bytes | 65536 |
|---|---|
| Manufacturer | NXP Semiconductors |
| Packages | QFP(48) |
| Part Number | LPC1115JBD48/303 |
| Vcc(program) | 3.3 |
| Package |