Renesas-M M37542F8GP QFP(32) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: This algorithm is written in Parallel I/O mode. In the buffer 4K-byte Boot ROM is mapped to 0000h-0FFFh.2K-byte Data (Block A) is mapped to 7000h-77FFh 2K-byte Data (Block B) ismapped to 7800h-7FFFh; 16K-byte FLASH (Block 2) is mapped to 8000h-BFFFh8K-byte FLASH (Block 1) is mapped to C000h-DFFFh8K-byte FLASH (Block 0) is mapped to E000h-FFFFh. Each block can be ERASED/PROGRAMMED separately by setting Ranges under Device/Options. The following range setting corresponds to each block: 0000h-0FFFh (Boot ROM)1000h-77FFh (Data Block A) 7800h-7FFFh (Data Block B)8000h-BFFFh (FLASH Block 2)C000h-DFFFh (FLASH Block 1) E000h-FFFFh (FLASH Block 0).*** Buffer locations FF00h-FFFDh are special programming incorrect data could causethe part to stop communicating.The ROMCP security byte is mapped to location FFDBh.To program the security byte in the Device/Configure menu you must select the appropriate optionin that menu AND you must set Secure After Programming’ to ENABLE in the Device/Options menu or use the Secure command. Otherwise the security option will not be programmed.*** Buffer locations 8000h-807Fh and FFFEh-FFFFh are reserved. These locations will not be programmedand will be assigned FFh when read back ***. ‘