BPM News and Updates
No Results Found
The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.
Off-line vs In-System Programming
In-system programming (ISP) allows some devices to be programmed after it’s soldered on the PCB board. This allows firmware updates and small data uploads, integrating programming and final test into a single step.
Tape In/Tape Out Video
Tape-In The X-Stream Series Tape Feeder System is the reliable, precise automated tape input peripheral for the BPM Microsystems automated programming systems. The X-Stream Series offers a broad range of carrier tape sizes, from 8 to 56mm. Tightly coupled with BPWin™...
Offline Automated Programming vs Inline SMT Programming
A small segment of electronic manufacturing companies can use inline programming solutions effectively and economically, compared to off-line programming. A lack of flexibility, high cost, and the specter of obsolescence should raise questions about the long-term viability of Inline programming.
About BPM Microsystems
BPM Microsystems is a global provider of device programming systems, test and measurement systems, factory integration software and solutions for the semiconductor and electronics industries. Founded in 1985, BPM Microsystems serves more than 2,000 programming centers, original equipment manufacturers, contract manufacturers and semiconductor manufacturers in over 49 countries.