Atmel ATMEGA16-16PC(Special) DIP(40) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: Buffer address range 0000h-3FFFh is FLASH Program Memory and 4000h-41FFhis EEPROM Data Memory. The Calibration Byte can be programmed into any addressin the Flash memory (from 0000h to 3FFFh) as well as any address in the EEPROMmemory (from 4000h to 41FFh). To make use of Calibration Byte set Device Configure CALIBRATIONto ENABLE then set Device Configure CAL BYTE ADDRESS to select one of theaddresses (0h-3h) in the signature row high byte for 1 2 4 or 8 MHz internal RCOscillator Calibration then set address under Device Configure CALIBRATION ADDRESS.New devices may automatically calibrate the RC Oscillator.Please set the CALIBRATION option to DISABLE(default) to use automatic calibration.You also can set the fuse from Fuse Low Byte and Fuse High Byte under Device Configuremenu. The fuses are mapped into the fuse bytes in the following way. Fuse Low Byte:[Bit0:CKSEL0 Bit1:CKSEL1 Bit2:CKSEL2 Bit3:CKSEL3 Bit4:SUT0 Bit5:SUT1 Bit6:BODENBit7:BODLEVEL]; Fuse High Byte: [Bit0:BOOTRST Bit1:BOOTSZ0 Bit2:BOOTSZ1 Bit3: EESAVEBit4:CKOPT Bit5:SPIEN Bit6:JTAGEN Bit7:OCDEN]. Please refer to the device specificationsfor detailed information.The Secure function whether during the program sequence or standalone will verify theconfiguration options and fail if any of them do not match the device settings.