Atmel ATmega328P-MU(Calibration) LAP(32) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASMR32MLFM | FASMR32MLFM |
Adapters for Manual Programmers
| 6th Gen | 7th Gen | 9th Gen |
| FSMR32MLFM, FASMR32MLFM, LASMR32MLFM (repl.) | FSMR32MLFM, FASMR32MLFM, LASMR32MLFM (repl.) | LASMR32MLFM |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSMR32MLFM, FASMR32MLFM, LASMR32MLFM (repl.) | FSMR32MLFM, FASMR32MLFM, LASMR32MLFM (repl.) |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: In the Buffer address [0000h-7FFFh] is the FLASH Program Memory and address [8000h-83FFh]is the EEPROM Data MemoryThis support is designed to calibrate the device to +- 2 percent of 8 MHz.There is a factory calibration Byte residing in the signature rowhigh byte of address 0h for 8.0MHz internal RC Oscillator calibration.Please use Atmel ATmega328-M for the support of factory calibration value.Enabling CALIBRATION under Device Configure will calibrate the deviceto +- 2 percent of 8 MHz using a 32.768 KHz clock. Then the calibrationvalue is programmed to an assigned address in the flash or EEPROM. Thisaddress can be assigned in CALIBRATION ADDRESS under Device Configure.Calibration result is valid to the socket module used to program the device.Results may vary for different operating conditions.
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Atmel |
|---|---|
| Vcc(program) | 5 |
| Packages | LAP(32) |
| Part Number | ATmega328P-MU |
| 8-bit Bytes | |
| Package | |
| ByteWidth | ATmega328P-MU(Calibration) (ID=950Fh) |
| VppProgram | 33792 |
| ElectricalErase | 5 |