Atmel ATtiny15L-1PI DIP(8) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: This device has a Fuse Byte that can be set under Device Configure menubit2 and bit3 are don’t care bits but per device specification they should be set to 1 during programming.Please see the device specification on the details of setting this byte.In the Buffer the first 400h bytes are for Flash and the rest 40h bytesare for EEPROM. Erase will erase both Flash and EEPROM. To programFlash or EEPROM read the device first then load data into thebuffer for the section need to program and leave the other section untouched.In Device Configure menu if CALIBRATION is set ENABLE the Calibration Byte canbe programmed into any address [000h-43Fh] in the Flash memory or EEPROM.The address is set in CALIBRATION ADDRESS option.CAL BYTE ADDRESS option is to set address 0h in the signature row high bytefor 1.6MHz internal RC Oscillator Calibration.New devices may automatically calibrate the RC Oscillator.Please set the CALIBRATION option to DISABLE(default) to use automatic calibration.COMPARE operation will only verify data read from the device against data in the buffer.Calibration byte will be ignored during compare regardless of the Calibration settings inDevice Configure menu.Device can only be verified at 4.5V and 5.5V due to High-voltage Serial programming mode.