Freescale Semiconductor MC9S08AC128CLKE QFP(80) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: The following describes the Data Pattern setup: Addresses [$20F0-$3FFF] are FLASH PPAGE-0. Only 7952 Bytes are supported in PPAGE-0. Addresses [$4000-$7FFF] are FLASH PPAGE-1. Addresses [$8000-$A0EF] are FLASH PPAGE-0. Only 8432 Bytes are supported in PPAGE-0. Addresses [$C000-$FFFF] are FLASH PPAGE-3. Addresses [$28000-$2BFFF] are FLASH PPAGE-2. Addresses [$48000-$4BFFF] are FLASH PPAGE-4. Addresses [$58000-$5BFFF] are FLASH PPAGE-5. Addresses [$68000-$6BFFF] are FLASH PPAGE-6. Addresses [$78000-$7BFFF] are FLASH PPAGE-7. There are some reserved locations in the FLASH memory map. The following are reserved addresses:[$FFB8-$FFBB] $FFBC and $FFBE. These locations will be ignored during Programand Verify. Erase command will be erase entire FLASH memory map included reserved memory. The lower two bits (Bit1 and Bit0) at address $FFBF are security bits (SEC01:SEC00). They are ignored during Program and Verify and read 1:0 if unsecured during Read and Compare. To secure the device use SECURE command. During Erase factory programmed trim value at addresses $FFBC and $FFBE will be saved first and restored at the end. Erase will fail if the device is secured. If the device fails erase the Factory Trim value might be corrupted. The part cannot be used unless re-trimmed. ‘