Freescale Semiconductor MC9S08GB60ACFUE QFP(64) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: The following describes the Buffer setup:Addresses $1080-$17FF are FLASH.Addresses $182C-$FFFF are FLASH.Some locations in the FLASH memory map are reserved : $FFB8-$FFBC and $FFBE.These locations will be ignored during Program Read and Verify.Erase command will erase the entire FLASH memory map including the reserved locations.Factory trim value can be restored by selecting the desired option under Device-Configure.If user selects to Preserve Factory Setting during Erasefactory programmed trim value at address $FFBE will be saved first and restored at the end.Erase will fail if the device is secured.If the device fails erase the Factory Trim value might be corrupted.The part cannot be used unless re-trimmed.The lower two bits (Bit1 and Bit0) at address $FFBF are security bits (SEC01:SEC00).They are ignored during Program and Verify and read 1:0 if unsecured during Read and Compare.To secure the device use SECURE command.