Freescale Semiconductor MC9S08GT60CFDE(Factory Trim) LAP(48) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASMR48QFN, FASM48QFN | FASMR48QFN, FASM48QFN |
Adapters for Manual Programmers
| 6th Gen | 7th Gen | 9th Gen |
| FSMR48QFN, FSM48QFN, FASMR48QFN, FASM48QFN, WASM48QFN (repl.), LASMR48QFN (repl.) | FSMR48QFN, FSM48QFN, FASMR48QFN, FASM48QFN, WASM48QFN (repl.), LASMR48QFN (repl.) | WASM48QFN, LASMR48QFN |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSMR48QFN, FSM48QFN, FASMR48QFN, FASM48QFN, WASM48QFN (repl.), LASMR48QFN (repl.) | FSMR48QFN, FSM48QFN, FASMR48QFN, FASM48QFN, WASM48QFN (repl.), LASMR48QFN (repl.) |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: The following describes the buffer setup:Addresses $1080-$17FF are FLASH.Addresses $182C-$FFFF are FLASH.There are some location reserved in the FLASH memory map.The following are reserved addresses: $FFB8-$FFBC and $FFBE.These locations will be ignored during Program Read and Verify.Erase command will be erase entire FLASH memory map included reserved memory.*** During Erase factory programmed trim value at address $FFBE will besaved first and restored at the end. Erase will fail if the device is secured.If the device fails erase the Factory Trim value might be corrupted.The part cannot be used unless re-trimmed.The lower two bits (Bit1 and Bit0) at address $FFBF are security bits (SEC01:SEC00).They are ignored during Program and Verify and read 1:0 if unsecured during Read and Compare.To secure the device use SECURE command.
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Freescale Semiconductor |
|---|---|
| Packages | LAP(48) |
| Part Number | MC9S08GT60CFDE |
| Vcc(program) | 3 |
| Package | |
| 8-bit Bytes |