Freescale Semiconductor MC9S12D64MFU QFP(80) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASMR80QCA, FASM80QCA | FASMR80QCA, FASM80QCA |
Adapters for Manual Programmers
| 6th Gen | 7th Gen |
| FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA | FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA | FSMR80QCA, FSM80QCA, FASMR80QCA, FASM80QCA |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: The following describes the buffer setup:Start address of EEPROM can be set under Device Configure.The EEPROM memory can be mapped to any 2Kbyte boundary in the MCU address ranges [$0-$FFFF].Please check data file. The start address of EEPROM must match the data file (Buffer).Addresses $F0000-$F3FFF are FLASH PAGE $3C.Addresses $F4000-$F7FFF are FLASH PAGE $3D.Addresses $F8000-$FBFFF are FLASH PAGE $3E.Addresses $FC000-$FFFFF are FLASH PAGE $3F.There are two security bits in the FLASH PAGE $3F.These bits (SEC01 SEC00) are Bit1 and Bit0 of address $FFF0F in the buffer.These locations will be masked out during programming and the entire byte at $FFF0Fwill be programmed to $00 when the device is secured.To secure the device please use the Device Secure command.Please set Device Options Byte order’ to: Big-Endian.This algorithm supports margin verification. ‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Freescale Semiconductor |
|---|---|
| Packages | QFP(80) |
| Part Number | MC9S12D64MFU |
| Vcc(program) | 5 |
| Package |