Microchip Technology PIC16F570T-I/SS SOIC(28) Device
Adapters for Automated Programmers
| 8th Gen | 9th Gen |
| FVE4ASMR28SSM, FVE4ASMR28SSM | FVE4ASMR28SSM |
Adapters for Manual Programmers
| 8th Gen | 9th Gen |
| FVE4ASMR28SSM, FVE4ASMR28SSM | FVE4ASMR28SSM |
Adapters for Engineering Programmers
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT:
| Device Type: | Microcontroller |
| Device Size: | 2 KWords Program Flash Memory with 64 Byte EEPROM |
| Algorithm Programming Method: | In-Circuit Serial Programming (ICSP) interface |
| Serialization Supported: | Yes |
Memory Organization:
| Memory Type |
Attributes(*)
|
Included in default Range (Y/N) | DUT Physical Byte Address(hex)(if this area is selected/Activated) | BPWin Buffer Byte Address(hex) |
| Program Flash Memory | R/W/E | Yes | 0000_0000h – 0000_0FFDh | 0000_0000h – 0000_0FFDh |
| Data Memory | R/W/E | Yes | 0000_0800h – 0000_103Fh | 0000_1000h – 0000_103Fh |
* R:Read only W: One time programmable (OTP) R/W: readable and one time programmable (OTP) R/W/E: readable and rewritable if not locked. Any configurations listed under ‘Device-Specific’ in the menu item Device-> Settings will be written to the DUT during ‘Program’ operation regardless of memory range selection. Special Device Considerations:
| 1. | Data pattern requires a 12-bit format for Program Flash memory. | |
| 2. | The ID locations are addressed in the Data Pattern at buffer byte address [1080h-1087h].It is recommended by manufacturer that the user use only the four Least Significant Bits of each ID location. | |
| 3. | Configuration words are located in the Data Pattern at buffer byte address [1FFEh(LSB)-1FFFh(MSB)].Both ID and Configuration may be set under Device > Configure or from the above mentioned addresses in Data Pattern. | |
| 4. | The Oscillator Calibration Bits are stored at the Reset Vector.To program these bits for custom trimming of the INTOSCyou must ENABLE ‘Erase before programming’ and also in Device Configure ENABLE ‘Customer Trimming INTOSC’ then set your desired value in ‘RESET VECTOR VALUE’. Otherwise these bits will be restored to the factory setting value. | |
‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| Manufacturer | Microchip Technology |
|---|---|
| Packages | SOIC(28) |
| Part Number | PIC16F570T-I/SS |
| Set programming | Yes |
| Vcc(program) | 5 |
| Package |