Microchip Technology PIC17LC756A/PT QFP(64) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: Programming the Microcontroller Configuration bits to PROTECTEDMode will cause the device to fail verify. This is because Protected modeencrypts the programmed data. To set this option please set Device/Option/Secureafter programming’ to ENABLE. Microchip does not recommend code protectingwindowed devices. This may inhibit the device from being able to be reprogrammed.To change your configuration bit setting please select Device/Configure.The Configuration word is located at buffer address 1FC00h-1FC01h.The Configuration word may be set from the CONFIGURE menu or from the abovementioned addresses in your data file. If using the buffer please note that bits 5 and 7 of buffer address 1FC00h should always be set to logic 1.Bits 0-5 of buffer address 1FC01h should reflect the same logic value as that of bit 7. Also note that according to the specification PM0 and PM1 should not both be set to Logic 0 at the same time unless the PM2 is also being set to Logic 0. ‘