Renesas-M M306NAFGTFP (ISP) DIP(14) Device
Adapters for Automated Programmers
| 6th Gen | 7th Gen |
| FASM48D300, FASM48D600 | FASM48D300, FASM48D600 |
Adapters for Manual Programmers
| 6th Gen | 7th Gen |
| FSM48D, FSM48DH, FASM48D300, FASM48D600, FSM48DB (obs.) | FSM48D, FSM48DH, FASM48D300, FASM48D600, FSM48DB (obs.) |
Adapters for Engineering Programmers
| 6th Gen | 7th Gen |
| FSM48D, FSM48DH, FASM48D300, FASM48D600, FSM48DB (obs.) | FSM48D, FSM48DH, FASM48D300, FASM48D600, FSM48DB (obs.) |
Last Updated: 05/18/2023
If the device is not yet supported by your BPM programmer (Generation), request Device Support
Note
IMPORTANT: *** THIS IS AN ISP SOLUTION SPECIFICALLY DEVELOPED FOR DEPHI *** ***TO PROGRAM THE BOARD CORRECTLY BELOW INSTRUCTIONS MUST BE FOLLOWED***Default Buffer Value’ must be set to 255 or FFh.’Automatic lowest address to load’ must be set to ‘Disable’.The User ROM area is located at address range C0000h-FFFFFh.There are 7 ID codes locate at FFFDFh FFFE3h FFFEBh FFFEFh FFFF3h FFFF7h and FFFFBh.If the flash is not blank the data at these locations in the buffer must match the ID codesin the device to enable the Standard Serial I/O mode. If the ID codes do not match communication cannot be established. If the device was previously programmed withanother set of ID codes a stand alone Erase operation must be executed with correct ID codesbefore attempting to reprogram the flash.For blank devices (factory programmed) Erase operation is redundant and should be disabled using Device/Options. ‘
BPM does not sell programmable devices, nor do we program devices directly. BPM makes programmers and accessories to make programming in-house fast, easy, and profitable.
Additional information
| 8-bit Bytes | 1048576 |
|---|---|
| Manufacturer | Renesas-M |
| Packages | DIP(14) |
| Part Number | M306NAFGTFP |
| Set programming | Yes |
| Vcc(program) | 5 |
| Package |