Renesas R5F10TPJLFB QFP(100) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: Single-wire UART Mode. 256 kB Code Flash is mapped to Data Pattern address 00000h – 3FFFFh. 8 kB Data Flash is mapped to Data Pattern address F1000h – F2FFFh. Boot cluster 0 is located in Clode Flash address 00000h – 01FFFh. Boot cluster 1 is located in Clode Flash address 02000h – 03FFFh. The Security Byte can be set under Device->Configure and programmed with Secure command. Security for this device cannot be verified. Security Byte: Set Bit 1 to 0 will disable Boot cluster rewrite. Set Bit 2 to 0 will disable Block Erase. Set Bit 4 to 0 will disable Porgram. Bits 0 3 5 6 and 7 are reserved and should be set to 1s. Bit 4 can be erased through Erase. Once bit 2 is programmed to 0 the whole chip is secured and no further operations can be performed. Once Bit 1 is programmed to 0 the boot block clusters specified are secured and no further operations can be performed. This algorithm supports Firmware version V3.03 and below.