Texas Instruments MSP430G2744IRHA40R QFN(40) Device

Adapters for Automated Programmers

Adapters for Manual Programmers

Adapters for Engineering Programmers

Last Updated: 05/18/2023

IMPORTANT: Microcontroller with Flash EPROM. Memory organization: Information Memory: 0800h-087Fh (Device Address 16-bit) 1000h-10FFh (Data Pattern Address 8-bit) Main Memory: 4000h-7FFFh (Device Address 16-bit) 8000h-FFFFh (Data Pattern Address 8-bit) Data Pattern locations 0000h-0FFFh(device location 0000h-07FFh) and 1100h-7FFFh(device location 0880h-3FFFh) are reserved and must contain data FFh. Each segment of the Information Memory and Main Memory may be Erased and Programmed separately. To access the Information Memory only set the Device Configure->Range between 0800h-087Fh (device address). Information Memory data will be displayed in Data Pattern locations 1000h-10FFh. To access the Main Memory only set the Device Configure->Range between 4000h-7FFFh (device address). Main Memory data will be displayed in Data Pattern locations 8000h-FFFFh To access both Information and Main Memory set the range as 0000h-7FFFh (device address). To overwrite calibration values and other information located in Information Memory Segment A at location 10C0h-10FFh select in Device Configure. Otherwise by default factory calibration values and other information in Segment A are preserved. For Compare Data Pattern location 10C0h-10FFh are ignored. Use Read to read those locations. Device address 7FE0h-7FFFh(Data Pattern location FFC0h-FFFFh) are Interrupt Vectors. Programming invalid data to these locations may prevent further access to the device.